Nikon Ai-S Nikkor ED 300mm f/4.5 IF Disassembly – Cleaning the Rear Element

Nikon Ai-S Nikkor ED 300mm f/4.5 IF Disassembly – Cleaning the Rear Element CAMERA Maintenance

The Nikon Ai-S Nikkor ED 300mm f/4.5 IF is a telephoto lens for Nikon F-mount cameras. This one is engraved “Nikkor ★ED 300mm 1:4.5”. I worked on it in November 2026. This post is a short disassembly to reach one dirty piece of glass: the rear element. On this lens it is not where you might expect, and getting to it means taking the barrel apart in the middle.

The Nikon Ai-S Nikkor ED 300mm f/4.5 on a dark mat
The Nikkor ED 300mm f/4.5, before the work
The large front element of the 300mm lens seen at an angle
The front element

1. Where the rear element is

On this lens there is no glass behind the aperture blades. The last piece of glass sits in front of the aperture, and that was the one that was dirty. You cannot reach it from the mount side, so the barrel has to come apart.

2. Splitting the barrel in two

The barrel of this lens can be split into two halves at the middle. Near the middle there is a small grub screw. With that screw out, the two halves turn against each other to loosen, and then they come apart.

A screwdriver on a small grub screw near the middle of the lens barrel
Taking out the grub screw near the middle of the barrel
The lens barrel separated into a front half and a rear half
The barrel in two halves
The front half with the focusing ring and the rear half with the aperture ring side by side
The front half (left) and the rear half with the aperture ring (right)

3. Taking out the rear element

With the barrel apart, the rear element is right there at the back of the front half. Under the light, its surface shows fine specks of dust and dirt.

The rear end of the front half held in a gloved hand
The back of the front half
Close-up of the rear element with fine specks of dust on it
The rear element, with fine specks on it

I unscrewed it from the back of the front half with a lens spanner, cleaned it, and put it back.

A lens spanner in the back of the front half to unscrew the rear element
Unscrewing the rear element with a lens spanner

4. Back together

Then the two halves went back together, and the grub screw went back in. Here is the finished lens held up to a light, seen from the mount side.

Looking through the finished lens from the mount side toward a light
Looking through the lens toward a light

This one is not listed yet. If you are interested in it, send me a DM on Instagram.

Thank you very much for reading.

Follow azuleterno on Instagram

I run azuleterno, a shop in Japan that sends good-quality used Japanese cameras and lenses to people all over the world. Like the lens in this post, items with minor problems are repaired and put in order before they are sold.

On Instagram I post the lenses and cameras I have just listed. Follow along to see what comes in next.

Questions, or looking for a particular lens or camera? Send me a DM on Instagram. Requests are welcome.

Shop worldwide on eBay

We sell good-quality items from Japan to buyers all around the world, and eBay is where we do it. Our items are listed in our eBay shop with detailed photos and an honest description of their condition, and we ship from Japan to your door.

When you find something you like on Instagram, this is the place to see it in full and buy it.

“For Your Happier Life, For the Future of Our Earth.” Giving well-made cameras a longer life is our small way of caring for the planet.


日本語

ニコン Ai-S Nikkor ED 300mm F4.5 IF は、ニコンFマウント用の望遠レンズです。この個体には「Nikkor ★ED 300mm 1:4.5」と刻まれています。2026年11月に作業しました。今回は、汚れていた1枚のガラス、一番後ろの玉(後玉)にたどり着くための分解の記録です。このレンズの後玉は思いがけない場所にあり、取り出すには鏡筒を真ん中で分ける必要があります。

1. 後玉はどこにあるか

このレンズは、絞り羽根の後ろにガラスがありません。一番後ろのガラスは絞りより前にあり、汚れていたのはそのガラスでした。マウント側からは届かないので、鏡筒を分解します。

2. 鏡筒を2つに分ける

このレンズは、鏡筒の真ん中で2つに分けることができます。真ん中あたりに小さなイモネジがあり、それを外してから回して緩めると、2つに外れます。

3. 後玉を外す

鏡筒を分けると、前半分の一番後ろに後玉があります。光に当てると、表面に細かいホコリや汚れの点が見えます。レンズ用のカニ目レンチで前半分の後ろから外し、清掃して元に戻しました。

4. 組み立て

2つを元どおりに合わせ、イモネジを戻しました。最後の写真は、仕上がったレンズをマウント側から光にかざしたところです。

このレンズはまだ出品していません。気になる方は、InstagramのDMでお気軽にどうぞ。

最後まで読んでいただき、ありがとうございました。

オールドレンズの分解清掃を承ります|Repair Factory Fuji Base

この記事のような分解清掃を、国内のお客さまのレンズでもお受けしています。静岡県富士市の工房で、カビ・くもり・絞りの油染み・バルサム切れの清掃を、1本ずつ作業します。

基本料金2,000円(税込価格2,200円)・返送料込み。料金表とお申し込みは、受付ページをご覧ください。

作業の様子は、Instagram @fujibase_repair でも紹介しています。

InstagramでazuleternoをFollowしてください

日本の良質な中古カメラ・レンズを、世界中の方へお届けしているショップ azuleterno を運営しています。今回のレンズのように、小さな不具合のある品は修理・整備してから販売しています。

Instagramでは、新しく出品したレンズやカメラを紹介しています。フォローしていただくと、次に入ってくる品が見られます。

ご質問や、お探しのレンズ・カメラがあれば、InstagramのDMでお気軽にどうぞ。

モットーは “For Your Happier Life, For the Future of Our Earth.”(あなたのより幸せな暮らしと、地球の未来のために)。良いカメラを長く使い続けてもらうことが、地球を大切にする私たちなりの方法です。

Comments

Copied title and URL